KP watertight concrete in concrete structures with repellents
cohesion is enhanced hydration, increasing the resistance
to shrinkage, and
micropores. reducing the long-term strength of concrete increases
with the bangsuryeok and there is no worry of corrosion. It is Life and prevent
condensation building superior effect of neutral type of
eco-friendly products with no
● Improve the cohesion of the mixture, the water-tightness of
concrete reinforcement
● Basement Waterproofing sphere retaining wall / tunnels,
bridges, road construction
● Overpass, dock, jetty, etc.
Construction
Method
Pouring concrete to a uniform thickness, and the thickness of
the rod-like vibrator, depending on the size of the vibrator
should be *0 ~ *0cm.
Compaction of the surface vibration in the vertical direction of
the insertion operation, and then to have
a sufficient fluidity
to the concrete material is gradually subtracted out when mixed
evenly. Vibration compaction should be
carried evenly on the entire area of the casting stick
together in one place, and the distribution of the concrete should
not use the vibrator.
Concrete foundation slab floor and the surface of the vibrating
compaction can use the vibrator.
Surface
Treatment
● Surface (cement powder, sand, dirt, oil, etc.) must be clean
to avoid
●Repair of Old coating after confirming the suitability of use
when painting.
How to
use
● *8L per ready-mixed concrete mix when placing the 6 ㎥
● Where a dam or reservoir and the water pressure strong pour
the mixture *5L for about 5 minutes per 6 ㎥.
● When mixed with cement mortar 0.3 to 0.5 percent by weight
of cement mix and use.
(Mixing ratio caused by the water pressure difference)
● After the ready-mixed concrete must be put into the mixture
for about 5 minutes.
● Below 5 ℃ or 5 ℃ to fall within *4 hours if the use
prohibited.
● Must not eat or drink, if it gets into eyes, rinse with
water
Curing
● If the general structure avoiding direct sunlight to
maintain a wet state.
● Prevent cracking, storage tanks and the waterproof poured on
concrete foundation for structures must be sufficiently
cured before getting the
water pressure.
● Waterproof concrete compressive force of the final must be
at least **0kgf/cm2.
● The regions where rapidly require the function as waterproof
concrete can be reduced curing and curing time rapid curing
by the use of curing
accelerator.
Mixing
ratio
Concrete
● 0.5 ~ 1.0% of cement
weight
● High water pressure
1%
● Low water pressure from 0.5 ~ 0.9 percent
Notes
● If rain is expected, please prohibiting construction
● Prohibiting the construction below 5 ℃
● Avoid too much direct sunlight summer season
● Wear protective equipment : safety glasses, protective
gloves, etc.
● Waterproof product of ready-mixed concrete, avoid direct
sunlight, please keep in a cool well-ventilated place
● Please keep out of reach of children
● Before using the product, by using a sufficient mixing
