Product Description

1 x *0W PUSH ***0V Dimmable LED Driver Multi Output Current **0mA****0mA
 
Description:
1, Multi-output can be selectable via DIP switch. Output current: **0mA to ***0mA, output voltage:*2Vdc and *4Vdc.
2, Dimmable LED driver with primary PUSH, secondary PUSH and ***0V dimming interface.
3, Jumper design for switching different dimming modes, it is very convenient to select suitable dimming function as you required.
4, Memory function: The driver has built-in permanent memory against power failure. Lights can return to previous dimming level when switch off and on again, even at mains restores.
5, Synchronization: thanks to the MCU programme, up to *0pcs drivers should be controlled by the same switch. This means there is no need for any additional synchrony wire in larger installations, where many drivers should be controlled by one switch.
6, Maximum length of the cable, from switch to last driver is *0m.
7, Factory setting: **0% dimming level and **0mA output.
8, Reset the LED diver easily by a jumper.
9, Press-in terminals in primary and secondary side, easy assembly.
*0, Protection: Short circuit / Over voltage / Over temperature.
*1, Long life span *0,**0h, 5 years guaranty.
 
Applications:
For LED panel light, LED down light, led strip, led tube etc…
 
Dimming Operation:
 
A) PUSH Dim
Short push (<0.1sec): Ignore, to avoid reaction on AC spike.
Short push (0.1~1sec): Switch on or switch off.
Long push (>1sec): Dimming up or down, dimming level automatically stops at minimum or maximum value.
 
B) ***0V Dim
Using the push dimming will make ***0V dimming inactivated. The driver has to be reset to active the ***0V dimming function again.
 
Synchronization:
 
For the resynchronization to work correctly when more than one driver is connected to the same push , follow steps of below after the drivers are connected:
 
A) Press push for more than one second, followed by a short push (<1s), now, led light switches off.
B) Do a long push, the system will be resynchronized.
 
Specifications