Product Description

APPLICATION PROCEDURE HYPERFINE INSULATION
AKTERM FACADE. 
 AKTERM FACADE has good adhesion to almost all known materials. It has low Newtonian flow, so when applied to vertical surfaces almost no effect of "sliding", even when applied in a layer thickness of 1 mm or more. Insulation work can be done on surfaces with temperatures ranging from *5 ° C to ***0 ° C.
 1. Prepare the surface.
1)To prepare the surface for application: remove loose sections, broaden crack, remove oily inclusion of cement concrete clean "milk", repair the surface (including the joints between the bricks to reduce material consumption and deeper grooves **7 mm) of cement- plastering compositions. Sweep surface is made by sandblasting, wire brush or abrasive wheels. Surface with any quality acrylic primer deep impregnation for concrete surfaces **2 times. Wait until dry. 
2). Preparation of insulating coating.
 AKTERM FACADE ready to use. Must be mixed, if necessary, add a little water before applying a pre-prepared surface. The amount of water (5 to *0%) depends on the temperature of the main application and the subsequent operation. Consult your nearest Akterm manager. With a large storage time allowed inside the package bundle fraction. DO NOT OVER-stirred
When using a drill - maximum mixing speed - ******0 r / min. Using the vertical displacement vane so immersed in the liquid portion of thickened, turn the drill and start slowly rotating blades, mixing clumps with a liquid. Stir until the product becomes like a cream. Approximate time of mixing - mixer for **5 minutes, stirring **7 minutes manually. If it is about removing condensate, "coat" of frost - the material is applied with a minimal addition of water, with a maximum interlayer spacing.