Product Description

Dentex Self-Etchingl One-Bottle Adhesive (SOA) is 7th generation (*-step) universal adhesive. DA is a single bottle adhesive consisted of methyl methacrylate monomers and solvent. It demonstrates a great adhesion to dentin and enamel. It is easy to use and less time consumed adhesive with multifunctions.

PACKAGES:
Type: self-etching 
Refill: Bottle (3.0 ml x1 and 5.0 ml x1 bottles)

COMPOSITION:
BisGMA
Photoinitiator
Stablizer
Acetone
Other additives

APPEARANCE:
Light yellow viscous liquid

FUNCTION:
Due to it self etching capability, it doesn't need any etching, rinsing and primer. So, the bonding could be completed by a simple one step in shorter time. Its good flowability, great wettability and permeability significantly improve bonding strength. In clinic practice, this adhesive will be applied on dentin or enamel surface following a light cure after evaporating solvent. The light initiates monomers via free radical mechanism to form a strong film which bonds with both composite and tooth structure.

INDICATIONS:
Ideal for all restoratives
Core build up
In-lay and on-lay
Veneer repairs, porcelain restoration, metal and non metal bonding

INSTRUCTIONS

(1)Preparation: isolate and prepare tooth.
(2)Cleaning: rinse the preparation with water.
(3)Drying: gently air dry until there is not visible water. Do not allow enamel or dentin to dry for an excessive period of time.
(4)Applying Dentex Self-Etchingl One-Bottle Adhesive (SOA): dispense **2 drops of SOA into a mixing well, apply enough SOA to the entire preparation with a little brush until a shiny surface is achieved and then wait for *0 seconds (SOA should not be applied too much). Use a gentle stream of air to evaporate the solvent for 5 seconds. (if using a non self-etching adhesive, an etching step should be used according to the manufacturer's instruction).
(5)Cure: light cure for *0 seconds at **0±*0mW/cm2. Keep the distance to exposure surface less than 4 mm.
(6) Finishing: After light cure, adjust restoration.

WARNING:
Do not use this product for patient who is allergy to methymethacrylate. Do not use this product with any material contained eugenol.  

PRECAUTIONS: 
Methmethacrylate resins may cause skin sensitization in susceptible persons. In case of contact, wash skin with soap and water. In severe situation, get medical attention.

ATTENTION : 
To exposed pulp, a pulp capping material such as Calcium hydroxide may be used before using this product.

This product contains acetone which is flammable. Avoid flam.

STORAGE:
Store at *5ºC or less in a cool and dry place and avoid direct sun exposure. Recap the bottle after use.

DISPOSAL:
After the product is used up, dispose it as normal medical rubbish.

SHELF LIFE:    1 year