Product Description

  Ecomax

        Worldly-wise motorists  is most certainly remembered of successful and
unsuccessful attempts to watersupply to the engine. This is due to the lack of
intelligent control systems and technologies that would optimize the flow of water
        The proposed system of water injection  is based on modern technology with the
use of a microcomputer and is a complete device that is installed under the hood of
the car.  
  Using  microcomputer  makes  the  system  of  water  injection  easy  to  use  and
configure. Also, the use of microcomputers accurately calculate and dose the required
amount of water, which depends on the conditions of the engine, its temperature,  turn
of the crankshaft, positions of the throttle damper and etc.  
  Water injection system allows you to:
     increase engine power *  
        reduce fuel consumption *
       eliminate detonation  
        reduce shock loads on the crank-piston group  
        eliminate carbon deposits in the combustion chamber  
        the use of fuel with lower octane  
        the possibility of the change parameter chip tuning without a firmware
controller car not even advanced users in process of the usages simple striking
on keys (for system  Ecomax! FULL )
        image of the consuption fuel
    
        In detail about installation on car and  and the functionality you can learn from
the instructions for the system  Ecomax  as well as frequently asked questions .
 
Some notes  
1. Maximum efficiency is achieved when water injection zabednenii fuel mixture up
to *0% (when properly configured, air / fuel ratio / water), depending on the
combination of factors.  
2. Maximum torque is available at the ratio of air and fuel *3,2:1  
3. Water injection - for forcing the engine is most effective in *0/*0 ethanol / water
(or methanol) and water. (on recommendation of foreign colleagues)  
4. Water injection requires the installation of an earlier firing angle (on 2  - 4 ), as
compared to conventional engine. In injection engines firing angle setting is made
automatically.  
5. Excessive advance ignition timing will cause the fall of power and overheating.  
6. Quality of spraying water mixture - is directly related to the effectiveness of the
system. Smaller droplets cool the combustion chamber better and more evenly.
7. Water injection allows you to operate at a higher compression ratio without
detonation on low-octane fuel. The higher the compression ratio increases the torque
and engine efficiency.  
8. Cooling potential hot spots in the combustion chamber eliminates surface ignition ,
which is the most devastating form of uncontrolled burning in the combustion
chamber.  
 
* - The effect can be obtained with susceptibility to detonation engine, increasing the
degree Burn it, increasing the boost pressure, using zabednennyh fuel mixtures and
low-octane gasoline.