Product Description

1.Model: TD**2 Touch dimmer switch on/of

V+ ***-DC positive

V- ***-DC negative

LED+ **- Output to LED Strip positive

LED- **- Output to LED Strip negative

2.Parameters

3. Function

Non-memory Touch Switch performs as below:

1) Originally Off when the power is connected.

2) Quick Touch (time is less than **0ms) can turn the light on and off. One touch to turn

on; another touch to turn off. The lamp is **0% bright when it is on.

3) Hold on touching (time is above **0ms) can adjust the brightness endlessly. It will

reduce the brightness endlessly to the minimum in 3 seconds holding on when the light is

on. It will increase the brightness endlessly to **0% in 3 seconds holding on when the

light is off.

4) Quick touch and Hold on touching can be chosen anytime without any collision.

4. Installation Instructions:

Step I:  Stick and solder TD**2 with led strip in led profile.

Step II:  Connect the light with power.

Step III:  The height of Spring is about *5mm, it could be cut to adjust the height of led profile.   The conductive spring needs to be covered by insulation material such as glass,

plastic or ceramic material. The max sensed thickness is about 3MM.

 

5. Attention:

1) Please make sure you use constant voltage driver instead of constant current driver.

2) Please make sure the positive + and negative - are correctly connected to the LED power supply, and the positive and negative cannot be reversed.

3) Please install the TD**2 in the aluminum profiles for heat-sink to avoid malfunction.

4) Please put 3M tape or thermally Conductive Adhesive on the bottom of PCB to avoid malfunction.

5) Please make sure that the max load is less then 8A to avoid malfunction.

6) Please make sure the spring will not contact any metal object to avoid malfunction.