a. Applications of Manual Molding Silicone Rubber
Manual Molding Silicone Rubber is mainly used for model design
of manual mold, PVC plastic molds, cement products, low melting
point alloy molds, alloy toys, plastic toys, electronics,
handicrafts, stationery, large-scale sculpture, reproduction of
cultural relic, shoe sole molds, pad printing allocation,
Electronic equipment antivibration, etc.
b. Model Codes of Manual Molding Silicone Rubber
HY***8# is applicable to make molds of smaller products and
the production will be **3 pieces.
HY***0#, compared to other two types, for its moderate
hardness and better quality & performance, its production will
be ****0 pieces.
HY***0# is applicable to large size products duplications and
Electronic equipment antivibration.
c. Operation Instructions for Manual Molding Silicone
Rubber
RTV*2 Manual Molding Silicone Rubber is a flowable liquid, and
the quality has nothing to do with the color. It consists of two
component. Part A is a flowable liquid silicone rubber, part B is
the curing agent. Firstly, after your previous work of dealing with
the original model, take some liquid silicone rubber , add 2%*3%
curing agent of the amount of silicon, and mix them evenly. Then
after vacuum-pumping the mixture, you can pour it into the mold
frame. The silicone mold will cured in **3 hours.
Note: The time for vacuum-pumping should be less than 3—5 mins
,otherwise, once the silicone rubber has cross-link reaction during
vacuumizing, it will not be operated.
FAQ of manual molding silicone rubber –
How to prevent silicone manual molds getting sticky?
The main reason for this problem is that you do not handle the
products or original molds well, then you should deal with the
original mold or products carefully before molding. Such as for the
products with a complicated pattern or a unsmoothed surface, you
should polish and clean the products after which it will be molded
,then spray the release agent. Normally, the release agent can be
Vaseline , detergent. liquid wax Etc. In practical process, you can
bush different release agent according to different material.
The second reason is that the operator pour the silicone into
the mold when the mixture is mixed evenly, then the finish silicone
mold will not cure and dry entirely.