Product Description

We dedicated with presenting an professional and extensive variety of Vacuum Cleaning Furnace, which are made by making use of excellent crude material.

Specifications

Pyrolysis Polymer vacuum cleaning machine: 
1. Automatic 

2. Precise temperature control 

3. Factory direct 
Vacuum cleaning furnace clean injection moulding: 

Vacuum calciner clean spinneret applied the principle that the synthetic polymer decomposed under the condition that isolating from the air in the vacuum state and the high temperature around **0 centigrade degree. 

The specification of vacuum cleaning furnace clean injection moulding 
1. Cleaning is totally automatic Electric supply Automatic. 
2. Precise temperature control. 
3. Suitable for different thermoplastic polymers, e. G. PET, PA, PP, TPE, PB, PBT, PC, PMMA, ABS, etc. 
4. Large industrial produce vacuum hot cleaner. 
5. Simple operation (Just need to turn on the heating switch). 
6. Perfect cleaning of the spinning board. 
7. Extension of the spinneret board's life as well as shorter working hours. 
8. Smooth nozzle hole. 

Suitable polymer of vacuum cleaning furnace clean injection moulding 
Polyolefin: PE, PP, PB...
Polyester: PET, PBT, PC...
Polyamide: PA6, PA*6...
Polystyrene: PS, SB, SAN
Polyurethane: PUR
Copolymer: ABS
Special polymer: PVC, PTFE, PPS, PEEK
 
Structural form
 
1. Vacuum hearth
Vacuum hearth is horizontal cylindrical, and consists of furnace cover and working
chamber of putting cleaned pieces. The waste collecting tank is at the bottom of the
hearth. In order to ensure the melting high polymer smoothly flow into waste collecting
tank, there is a funnel-shaped pallet at the bottom of furnace, and located right above the
waste collecting tank. Exhaust gas outlet ( vacuum inlet ), air for oxidation inlet and
heater installation hole are all in the hearth. High-quality aluminosilicate fibers is filled
between the hearth and outer barrel to heat insulation.
The hearth material is SUS**4 stainless steel, and furnace outer barrel is high-quality
Q**5A structural steel.
2. Stainless steel electrical heater
The vacuum calciner heater is made up of six "U" type stainless steel electric heat pipe.
Heaters are installed in the surrounding of the hearth, the line stretches out the furnace
passing through the insulating layer from heater install port, and a junction box in the
outside of furnace.
3. Waste collecting tank
Waste collecting tank is horizontal, inside is a semi-circle drawer to put the waste,and it
is easy to pour out the waste when you pull out the drawer.
4. Spray washer
The ash content produced in the anti-blocking device is cleaned by the spray washer and
then flow into the water-ring vacuum pump. The spray washer consists of stainless steel
barrel and water spray header, stainless steel pall ring for filtration is setted in the barrel,
and spray water is the inlet water of the water-ring vacuum pump. The water supply of
spray washer is made up of solenoid valve and flowmeter.
5. Seal
The furnace cover and door is sealed by double seal-rings, and sealing material is the
heat-resistant flexible graphite packing. Waste collecting tank is sealed by heat-resistant
silicon rubber.