Product Description

Cement Flue Pipe Forming Machine for kitchen and toilet
Technical data of Cement Flue Pipe Forming Machine for kitchen and toilet:
Power: 220 v
Transmission mode: mechanical transmission
Molding cycle: 15 minutes

Specifications:
25 × 30cm 30 × 35cm 30 × 40cm 35 × 40cm
35 x 45cm 35 x 50cm 40 x 50cm 45 x 55cm


Material: Cement
Voltage: 380v customized
Compressive strength: 3.8
Maximum pressure: 13.9KN
Application: Cement flue/building ventilation flue
Material: Carbon steel
Type: Cement machinery

Features of Cement Flue Pipe Forming Machine for kitchen and toilet:
1. Convenient use:
Can make a variety of shapes, a wide range of uses of ventilation flue.

2. High efficiency production:
Simple and convenient operation, easy demoulding, low requirements for production technology; Mold production, wall thickness uniform, one molding, high strength, high yield.

3. Good finished product effect
No deformation, no crack, good volume stability, simple construction operation.



Flue machine operation method:

1. Open the machine, brush a layer of oil on the contact surface of inner and outer mold products to facilitate demoulding; At the same time, open the air compressor and begin to expand the mold to the standard pressure.
2. Put a circle of mesh cloth or wire mesh around the outer part of the inner mold;
3. Put the mixed mortar into the gap between the inner mold and the outer mold until it is filled;
4, start the vibration pump, and gradually add cement mortar to the site, and shut down the vibration pump when the cement mortar is static.
5, internal heating, speed up the initial setting time of cement;
6, when the cement surface reaches a certain hardness, begin to demould, first close the left and right sides of the inner mold, then close the upper and lower sides, limit switch control its stroke;
7, along the direction of demoulding gently push cement products can easily demoulding, demoulding respectively reset the inner mold up and down and left and right sides;
8. Transport the cement products to the waiting area by rotating car, repeat the above operation, and start the production of the next product.