Product Description

Damisol ***2/**0
Have a very stable, resin and high reactivity
Were class H (**0 C) of the heat level
The mechanical properties were excellent and durable
Have a high flexibility resin
summary
Chemical composition: one heat resistant unsaturated polyester resin.
Light yellow transparent resin, using styrene as active diluent, after curing has good heat resistance, can be used for the highest to H level (including H
Level) insulation system.
High reactivity Damisol ***2 is a very stable one component resin can be used for various continuous impregnation process (immersion, rolling leaching and
Drop dip), also used in VPI process.
application
Continuous impregnation (immersion, roll and drop) for various types of coils, in particular for motor stator and rotor coils, which require high mechanical properties.
technology
Resin ***2 can be used for any kind of manual or automated immersion, roll or drop equipment for insulation treatment. Even in the absence of preheating
In the case of low viscosity, the resin has good permeability to the resin. The process parameters and the resin viscosity of the equipment can be selected according to the type of the motor.
***2 the design of the resin viscosity is **0mPa.s, but according to the need to use ***7 thinner to dilute it to lower viscosity, so that it can
Enough for the impregnation of the thin copper wire that is difficult to penetrate.
Cure condition: ****5min (the temperature is copper wire temperature) **0.
Higher curing temperature or longer cure time is necessary to obtain higher mechanical strength or chemical resistance.
The resin should avoid being contaminated and subjected to high temperature ( packing
*0kg drum
**0kg drum
Storage condition
Storage in closed and away from the light vessel, one component resin ***2 at *3 DEG C and a shelf life of at least 6 months and in *5 DEG C shelf life to
Less for *2 months.
If the resin is stored in a storage tank, it is recommended to store the resin (dry air or nitrogen) at atmospheric pressure. Resin is not completely filled in the storage process
The stability of the resin was favorable, and the recommended filling ratio was *0%.
Open the lid, regularly mixing can make oxygen to penetrate into the resin, which can improve the applicable period.
health and safety
Avoid any contact with skin and eyes;
Operate in a well ventilated area, away from the flame;
Wear safety gloves and goggles.
Specific information may refer to the material safety data sheet.
Unit resin test standard
physical property
The flash point is greater than or equal to *2 DEG C
Gel time (**0 degrees C) **5 min
Viscosity (Brookfield, *3 C) mPa.s **0 + *0
Shore hardness D *8 ISO **8
Volatile organic compounds content less than *7 IEC ******3
Chemical properties
Water absorption (7 days *3 C water)% less than or equal to 0.*3 ISO *2
Resistance to liquid chemicals (2% caustic soda)% ISO *0.*4 **5
Electrical properties
Dielectric strength (*3 C, *0%R.H) kV/mm = **0 DIN ****8/VDE ***0
Mechanical properties
Bond strength (*3 C) daN *5 IEC ***3
Bond strength (**0 C) daN *0 IEC ***3
Bond strength (**5 C) daN *8 IEC ***3
Bond strength (**0 C) daN 8 IEC ***3