Description

AIR-OIL HEAT EXCHANGERS The use of air for cooling hydraulic is becoming more and more frequent, than that of water-oil cooling. This is due to a number of reasons. 1. Lack of water: The plant is not connected to the water mains. 2. The operating cost is lower than that of water-oil heat exchangers, even though the initial investment cost is higher. 3. Considering the cost of piping, to purchase water, pump it, or perhaps treat it before use or after discharge. PLATE-FIN HEAT EXCHANGER The plate-fin heat exchanger is characterized by its compact, lightweight, efficient design. It provides significantly more cooling per cubic inch than the other designs described earlier. AH Series Plate-Fin Heat Exchanger - Drain type Characteristic: 1. AH series are special designed for return line system, Maximum working pressure reaches *0 bar. 2. High density of fins are made by aluminum, increasing the cooling surface and very light of weight. 3. Three types of capacity for chosen. 4. All electric motor has CE certification and very low noise when operation. 5. Maximum working pressure *5 bar. AW Series Plate-Fin Heat Exchanger - Drain type Characteristic: 1. AW series are special designed for high pressure variable displacement pump drain cooling system. 2. High density of fins is made by aluminum, increasing the cooling surface and very light of weight. 3. Three types of capacity for chosen. 4. All electric motor has CE certification and very low noise when operation. 5. Maximum working pressure *5 bar. AL Series Plate-Fin Heat Exchanger - Drain Type Characteristic: 1. AL series are special designed for Drain cooling system. Normally it was applied in the drain pipe of variable displacement pumps and pump working pressure should be *0 bar max. 2. High density of fins is made by aluminum, increasing the cooling surface and very light of weight. 3. There are different types of electric fan