Description

LEXIA*3 Interface latest version V*3 , works for both Citreon and Peugeot! Description LEXIA*3 Interface latest version, works for both Citreon and Peugeot! Dealer diagnostic scanner for comprehensive Citroen and Peugeot cars diagnostic. You can do all as a authorized dealer ***** diagnostics software allows you to perform complete diagnostics of all from ***5 untill present models. Diagnostics is performed via OBD-II connector (which is located near steering wheel) or via manufacturer-specific connector (only older cars, pre****1). Supported functions Unlike other universal car scanner tools which only read fault codes, this software performs nearly ALL the functions like the original dealer diagnostic tool. Our diagnostic interface contains K-Line multiplexor, CAN-BUS interfaces and SAE J***0 bus (both PWM and VPW). The following diagnostic functions are supported: Read identification Displays complete identification of control unit, ***** part number, software/hardware version, manufacturer, ***** Read fault codes Displays all stored and pending fault codes with complete description (***** "Rail pressure - too low pressure"). Program supports report printing or copy to clipboard. Clear fault codes This function clears all stored fault codes and other diagnostic information. Auto-scan (complete car scan/test) Detects all ECUs (electronic control units) installed in car and reads all diagnostic fault codes. Measured Values Program displays live Data like Engine Speed, Battery voltage, Oxygen Sensor, Coolant Temperature, etc. Values can be displayed in graph, 9 values at once, or full listing (all measured values). Logging to file is also supported, which allows offline analysis. Actuator test Actuator test activates particular actuator (***** turn on fuel pump, lock/unlock wheel, lock/unlock doors, cut off fuel, *****) Programming functions/Adaptation This feature is of great importance in all vehicles because systems like Engine control units, Immobilizers, Airbags, Alarms, Body Control Units, and some others, require you to perform reset or programming procedures after car repair is done, or even configuration after replacing broken Control Unit. Hardware and software requirements Software requires at least Intel Celeron/Pentium III **0 MHz, **8 MB RAM, *0MB free HDD space and USB 1.1 port (USB 2.0 recommended) and Microsoft Windows *8 SR2/***0/XP with the latest service pack installed. If customer requires, we can prepare ready to work PC. Set includes: * Main unit with OBD*2 cable * *6pin F to 2pin cable * USB cable * Software CD