Description

Follwing details are needed in installation of a recycling system - How much capacity needed of this line - Defining the amount of spoilage or contamination in the will recyled material. - Defining the final usage of the finished product. Based on these specifications we would design and manufacture a complete modular system for the application. The modular system maybe consist of: Bale breaker: For debale the baled PET bottles Belt conveyor: Transport materials Screw feeder: Transport materials as well as rub them for surface clean Metal detector bridge: For detection of NE metal and protect the granulator and washing components Separation table: For separate the foreign materials manually Crusher: Crush the materials to flakes of *5mm (two series: one for PET, one for PP/PE) Hot washer: clean the materials in hot water, sometimes with some chemicals Poaching tank: For separation of the flakes with a specific density of <1g/cbm from >1g/cbm or in contrast to separate the flakes with a specific of > 1g/cbm form <1g/cbm ( PET >1g/cbm and PP/PE <1g/cbm ) Friction washer: Surface clean the materials ( two series: one for PET, one for PP/PE) Dewatering machine: for mechanical surface drying of the material flakes with rotating roller ( two series: one for PET, one for PP/PE) Blowing and drying system: 1. For discharging and transporting the material from the dryer 2. For final drying of the material to the necessary residual level for down stream material processing Cyclone silo: 1. for separation of dust and fine material to achieve a better quality final product 2.Storagefor the final products