FOB Price
Get Latest Price12 USD/PC /
|Minimum Order
Place of Origin:
-
Price for Minimum Order:
Minimum Order Quantity:
50 PCS
Packaging Detail:
-
Delivery Time:
-
Supplying Ability:
2000 pcs
Payment Type:
-
Contact Person Mr. zhengqi
No 88 building Zhoujiaxiang village Hutang town Wujin district, Changzhou, Jiangsu
1ãB**0 Series freewheels are the same as B**0ï&frac*4;shaft mountedï&frac*4;so the shaft on which the clutch is mounted must be hardened to HRC****0 and 1.5mm case depth after grindingã Grind to 0.4Sï&frac*4;*6micro-inchï&frac*4;finishãThe taper of this shaft should not exceed0.*1mm per *0mm. 2ãFor installation of the clutchï&frac*4;mount the clutch with bearings at both sides or on one side in order to obtain comcentricity between the shaft and the clutch outer race and to take up radial or thrust loads which may work on the outer race or the shaft. See the installation example. 3ãThe clutch should be mounted on the shaft by rotating it in the direction marked by the arrow shown on the clutch plate, DO not apply shock to the clutch by hammering. 4ãThe clutches have the same outside diameters as the bearings shown in the table above. Bore tolerance of the housing in which the clutch is assembled should be within the range shown in the table below. 5ãFor indesing, oil lubrication in recommended. 6ãConcentricity of the housing bore and shaft should be within 0.*5mm.