Description

Transformer Radiator and Corrugated Wall Panel Radiators Radiators are Manufactured from Cold Rolled Continuously Annealed (CRCA) Sheet of 1.*0 to 1.*5 mm Thickness. We can supply 2 types of radiators as the follows 1. Corrugated Wall Panel Radiators: The Corrugated Type are directly welded to the Transformer Tank. Besides of the obvious advantage of REDUCTION IN THE OVERALL DIMENSIONS OF THE TRANSFORMERS, The Thermo power wastage is lower and the flow of oil does not become sluggish hence the efficiency of the Radiators is better. This in the long term improves the usable life of the Transformer and maintenance cost would be lower. Because there is no circulation of oil through Tubes/ Fins & therefore, there is no possibility of blockage due to formation of sludge. In case there is leakage or pilferage of oil, the level of oil may reduce but the Transformer will continue to operate with some increase in temperature. And for the transformers with fin type Radiators the circulation of oil will completely stop and the Transformer will burn off. 2. fin type Radiators Technical standards: IEEMA, DIN, JB/T******9, and custom designs RADIATOR SIZES: Width Centre Distances No. of Fins **0mm **0mm to ***0mm 6 to *9 **0mm **0mm to ***0mm 5 to *0 **0mm **0mm to ***0mm 5 to *0 **0mm **0mm to ***0mm 6 to *0 Accessories such as M.S. Square Flanges, Air Vent, Drain Plug, Lifting Hooks, Bracing Straps are standard but can be supplied as per customers specific requirements. Surface: All radiators are thoroughly cleaned and given a Interior Coat of class "B" Insulation Varnish. external surface is cleaned of all Rust and galvanized treated or Coat of Red Zinc Chromate Primer (*5 PPF). All radiators are Pressure tested individually under water with the help of Compressed Air Pressure of ***0kpa for *0 minutes.