Description
Combined machine
TP****6
Single Phase /
Three Phase
Very fast and practice
machine. Particularly suitable
for work with small rod irons, for the production of stirrups with diameter between
4 and *6 mm. Solutions suitable for worksites with fairly high work
outputs but without special requirements; designed for the
production of large numbers of stirrups. These rod-bending units
feature a cutter welded on one side, designed to cut and bend bars
for reinforced concrete. An affordable and compact combined unit,
ideal for smaller worksites. Important: The combined units have not
been designed to cut and bend iron at the same time. Gears and
pinions made of special hardened steel feature continuous oil-bath
operation inside a sturdy reduction gear casing. Both single-phase
and three-phase versions are available.The Single Phase
is equipped in inverter for minimize power consumption without loss
of the power. Heavy and carring struture. The machine is made of
two blocks. The upper part is easily removable for any type of
maintenance. In this machine have been installed sensors
eliminating maintenance of the traditionalposition switches.All parts are
painted with powder eletrostatic paint (polyepoxide) allowing
protection in time. All machines comply with current EC
regulations and
relevant safety at work.
Electric
motor(Single Phase / Three Phase) KW 1,5 / HP
2
Bending Speed (RPM)
*4
Weight(kg) **0
Dimensions(cm) *0 / *9 / h
*6
BENDING and CUTTING
CAPACITY
Capacity Mild / High Tensile Steel R = *5 kg.
/ mm²
Number of bars 1 Bar diameters
*5
Number of bars 2 Bar diameters
*2
Number of bars 3 Bar diameters
*0
Capacity Mild / High Tensile Steel R = *5 kg.
/ mm²
Number of bars 1 Bar diameters
*6
Number of bars 2 Bar diameters
*2
Number of bars 3 Bar diameters
*0
Standard Equipment
- Pedal for electric control
- Bush Holding Pins, Stirrup Bending Pin
- Checking Block
- Set of Bushes
Optional
- Angle Control
-
Stirrup linear measurer can be used also with stirrup bender
- Bending arm in steel to make large radius bending
- other bushes
Technical Features
- Reduction gear in heavy carpentry with parallel aces with gears
and pinions in steel in bath of oil, with reductions to increase
the bending power.
- Rotating disk in special steel.
- Movable saddles in hardened and tempered steel.
