Description

1. Application of signal enhancer
No signal repeater is applied but only when the installed receiver (the host) can not receive all the signals sent out by the pager.
2, Detection and installation of Signal enhancer
When the power is connected, red light flashes, yellow light flashes as receiving signal, , green light flashes when transmitting data.

(1) Firstly, not fixed the location of the signal repeater after detecting signal repeater proper working order.
(2) Two antennas are at *5 ° Angle with the ground after pulling out.
(3) Selection of the antenna length: Due to the different installation sites of repeater as well as their various differences, the length of the antenna is not fixed, the longer the signal is the better, therefore it is recommended that customers make test in the installation process, close to the yellow light for the receiving antenna, close to the green light for the transmitting antenna, antennas is total four section, the **4 comparison tests will be done to find an optimal length in installation process).
(4)The signal repeater after it is connect to the power starts from the farthest end of pager moving to the direction of receiver. The farthest pager is pressed continuously as well as the signal repeater moves all the way until the position where the yellow light does not shine as the pager pressed, then the repeater comes back slowly until the yellow light will flash when the farthest pager is pressed every time, this is the best position to install the signal repeater.
(5)Mounting fixed repeater.