Description
Introduction
The FP series
water chilled fan coil units are designed specially to meet the
varied requirements of zone cooling or heating using chilled water
or hot water. Fan coil can be applied to two or four pipe systems
to satisfy the requirements of a wide variety of air conditioning
or heating application. The FP series is available in concealed and
exposed versions for ceiling and floor installation. This unit is
presented as a single block including: fan deck, cooling and/or
cooling coil, removable filter, drip tray, electrical connection
box and decorative cabinet (excluded for concealed
version).
FEATURES
INSIDE
UNIT
Panels and frame
are made of galvanized steel, properly punched and punched for
fixing both accessories and the unit itself, either to wall
(vertical version) or ceiling (horizontal version).
HEATING
COIL
The coils are
made of seamless tubes expanded into aluminum fins in continuous
block. The connections have brass headers with female fittings and
provided with easily accessible vent and drainage
valve.
FAN
DECK
The fan decks are
composed of double suction centrifugal fans with aluminum impellers
and *-speed fan motors. Each fan motor assembly is dynamically
balanced.
FILTER
The easily
removable filter is made of filtering honeycomb polypropylene
fabric and supported by an aluminum or plastic frame.
DRIP
TRAY
The drip trays
are made from sheet metal treated with polyester powder coating to
ensure total resistance to atmospheric agents. The “L” type tray
makes the units suitable for both vertical and horizontal
installation.
ELECTRICAL
CONNECTION BOX
All electric
wires are connected to enclosed electrical terminal block, situated
on the opposite side to the water connections.
DECORATIVE
CABINET
The decorative
cabinet has a modern design that blends in with any environment.
It’s made from galvanized steel treated with polyester powder
coating to ensure total resistance to rust, corrosion, chemical
agents, aliphatic solvents and alcohols.
The discharge
grille and supporting legs are made of ABS materials.
ON-BOARD
THERMOSTART
Mechanical type
for two pipe system exposed version use, working mode selection
(OFF-Heating-Cooling), ventilation (HIGH-MED-LOW) and room
temperature setting.
OPTIONAL
1. Condensation
tray (water connection area)
2. Different type
thermostats with more advanced functions
3. High external
static pressure *0Pa and *0Pa
