Description
ceramic industrial heaters for blow molding machines
Features:
Ceramic band heater by Bossetool Company provide
long life and use less wattage because of insulation in plastic
extrusion and injection molding application.The heater is
constructed with a stainless steel shroud enclosing high quality
ceramic knuckles through which runs coiled high Temperature
nickel-chromium element wire.Configuration choices allow selection
of one or two piece, Heaters type of closure,and type of lead/post
terminals.
Advantage of Ceramic Band
Heater:
• Lower operating cost.
• Operate comfortably.
• Longe heater life.
• Highe operating
Temperatures.
• Flexible.
• Dual heat transfer.
• Maximum
Production
• Fast Heat – Up
• Unaffected by expansion and contraction of part being
heated
While Ordering Ceramic Insulated Band
Heaters,Please specify the following:
•Inside diameter of Heater Band (or the outside
diameter of the part around which the heater is to fit)
•Width (frequently referred to as "length")
•Type of line connection (i.e.Screw Terminals, Flexible Leads
etc)
•Opening between lock-up flanges (standard gap is approximately *0
mm). A larger opening might be required if temperature control
instruments etc are to be inserted at this point.
•If any clearance holes or cut-outs are required in the body of the
heater, the size and location (preferably by sketch)
•Watts
•Volts
Application:
• Blow Molding Machines.
• Injection Molding Machines.
• Extruders
• Blow Film Dies and Various cylindrical
applications
