Description

SGH-S*-PE type PE paint spray gun, combined with the principle of the stud gun by a special structure, the different components of the paint or liquid external mixing spray gun, in order to achieve the purpose of the solution was mixed externally. So as to reduce the phenomenon of mixed waste and scrap of raw materials. Usually for spraying PE paint or other two-component paints, and the solution is the best choice of the two-component paint. Choose SGH-S*-PE-type PE paint gun, you can increase your productivity, reduce your loss of raw materials, in order to achieve lower costs, higher use of tools, and the purpose of creating a higher efficiency. Technology parameters Pressure: Maximum material pressure: 0.6MPa (6bar) Maximum materialization air pressure: 1.2MPa (*2Bar) Minimum atomizing air pressure: 0.5MPa (5Bar) Materials pipe connection: Material hose 6 * 4 Materialized air hose: Plastic hose NW8 / 9 and G1/4AGA Weight: About **0g Noise: ****6 dB (about 1 meter of the gun of the distance measurement) Maximum operating temperature: *3 �° C OptioFive of the update 1, Nozzle integrated into one of formula 2, A liquid inlet design more reasonable 3, The new design of the gun linked 4, Increase the control valve 5, A gas inlet design simpler Nal materials nozzle: Caliber were 0.5, 0.8, 1.0, 1.2, 1.5, 1.8, 2.0 Maintenance When do maintenance you must: Cleaning the gun to stop the supply of compressed air to stop the supply of materials, not residual air pressure in the gun. Vulnerable parts such as seals, nozzle and needle gun must be checked regularly. The degree of wear is because the spraying of materials differ. From the leak, the leak and spray shape change can determine the parts for wear. Nozzle and needle guns must be replaced at the same time. You can not use a hard and sharp tools to clean the nozzle and gas cap.