FOB Price
Get Latest Price|
Minimum Order
Place of Origin:
-
Price for Minimum Order:
-
Minimum Order Quantity:
25 Liter
Packaging Detail:
25 Liter
Delivery Time:
07 Days
Supplying Ability:
25 Liter per Week
Payment Type:
Other
Contact Person Rajendra
Mumbai, Maharashtra
RXSOL***********5
Latex Remover Application: Use for Tank cleaning of Cargo tank,
Tank Container and Storage Tank. Also use in workshop as a stripper
to clean the lates from floor. Dose: 1. Butter worth the tank after
discharge without any delay for 2 hours with warm fresh water and
inject from the beginning on the RXSOL LATEX REMOVER. Make the
solution of Rxsol Latex Remover ***0% with water for tank cleaning
procedures. Allow product to soak for *0 minutes and flash down
with fresh water. Same for circulation method where time for
circulation could be between **3 hours. An additional circulation
could be necessary when deposits of Latex are quite heavy . Spray
RXSOL LATEX REMOVER at ambient temperature and allow approximately
*0 minutes activation time. The latex can then be removed with cold
water by means of high pressure. If necessary, repeat this
treatment. 2. Ventilate, mop and dry the tank. Some minor dried
latex residues which could be present on heating coils and pump
body have to be removed manually.Recommended preparations before
loading and discharge of Latex: Prepare the loading/discharge
connection directly at the pump stack of the respective tank and
flange off the line to the manifold. Install a valve at this
connection and use hoses for the shore connection (necessary length
should be as short as possible). Close the drop line inside the
tank by a flange or alternatively with wooden plug.If a plug has to
be used cover this with plastic foil (at least 3 layers) and fix it
with a stainless steel band. For loading and discharge use the deep
well pump only. All other connections and openings inside the tank
should be dismantled, flanged off or protected as described above
(e.g. steam, nitrogen,vapour line connections etc.).Fixed tank
cleaning machines should be dismantled and blinder flanged. Tank
dome hatches and Butter worth hatches including gaskets should be
protected with a plastic foil which has to be placed between the
dome and the hatch. Before loading steam the tank with very low
pressure (1 bar) to make sure that the bulkheads, tank top, bottom
and the lines inside the tank are humid but avoid any heat up. All
equipment that might come into contact with the Latex should be
washed with fresh water so they are humid before the loading takes
place.
Features
high pressure
Some minor dried latex residues
alternatively with wooden plug