Description

NEW SHARP BIG SPINDLE BORE PRECISION LATHE
MODEL: ***0X - Heavier Pattern Model

FEATURES
- Swing *5" - *0", center distance *0" - **0", spindle bore 6", 9",
& *2.5" (see our other listings for the full range of sizes)
- *8 spindle speeds, optional variable speed with 4 step changes
- Electromagnetic spindle brake
- Machine bed and base made out of one piece casting
- 6 way lever control of feed and rapid traverse for carriage, cross
slide & compound
- **0 threads for inch, metric, module and diametral pitch by
direct selection
- Additional hardened and ground way for support of apron
- Tailstock has Hi-Low gear for quill feed, also equipped with
"tang" and built-in stopper to help in heavy drilling

CAPACITY
Swing over bed: *0"
Swing over crosslide: *7"
Swing over gap, width: *0", *4"
Distance between centers: *0"
Bed width: *2"

HEADSTOCK
Spindle taper/bore: A***1 (6.*2") is standard, or A***5 (9.*5")
and A***0 (*2.*1") are optional at extra cost
Spindle Speeds (*8): 6 - **0 RPM
Vari speed (optional): *8 - 1,**0 RPM, *6 - **0 RPM, *2 - **0 RPM

CARRIAGE
Cross slide travel: *1.5"
Compound travel: *7.7"
Longitudinal feeds: 0.***8 - 0.1 inch per revolution
Cross feeds: 0.***9" - 0.*5 inch per revolution
Long. rapid feeds: *0 inch per minute
Cross rapid feeds: *0 inch per minute
Threads: metric: ***6(*0), inch: 1/***8(*0), module: 0.****4(*0), DP: ****2 (*0)
Leadscrew pitch: 2 teeth per inch

TAILSTOCK
Quill travel: 7.*7"
Quill diameter: 5.*5"
Quill taper: MT #6

GENERAL
Main motor: *0 hp
Net weight (approximately): *0,**0 lbs

STANDARD EQUIPMENT
Spindle sleeve, coolant system with pump & hose, halogen work
light, dead centers (2), chip guard on compound, indexable (8
positions) 4 way toolpost, toolbox & tools.

OPTIONAL EQUIPMENT (Call for prices)
*-Jaw chuck, face plate, steady rest, rear chuck adaptor, taper
attachment, variable spindle speeds (4 steps), semi-automatic
threading and turning cycle, & constant surface speed.