Product Description

Compare with T**0, IRDA WELDER add a Rework **6 and a **6 switch, more concenient than before. 1. Adopt infrared weld technology which independent exploration. 2. Use infrared heat, it is easy to cut through, heat proportion piercing tradition weld machine with sirocco. 3. Easily operate.Just need one day ***** operation this machine. 4. No need weld tools, it can weld all the component of *5x****5x*5mm. 5. This machine has **0W heating system.widely to *0x**0mm. 6. Infrared heating no have sirocco flow. Don't impact perimeter small ***** suitable for all of the component, especially Micro BGA component. Parameter： Working voltage : AC**0V *0Hz Output power: **0W Temperature: **0℃***0℃ Operation method 1、Boot. ①Check the power source, wind the plug. ②Turn on the power source.Don’t use until pass check.Pand will display enactment value.When last time used. ③Installation the repair ***** the line on the strip rack.Screw the light system height.Keep ****0mm between light and welder machine. ④According to measurement of welder piece.Proprictily screw ******0℃***0℃.When you strip *5×*5mm ***** temperature ******0℃.When you strip *5×*5mm ***** temperature ******0℃.The temperature come up to **0℃.The light system will shoot straightly.Please pay more attention to yourself control time.avoid burn out. ⑤Screw ***** light system smallest diameter is *5mm .the biggest is ***** keep ****0mm. ⑥Turn on the two ***** control warm-up plate and light system. 2、Dismantle and weld。 ①Regulate temperature , make the chip focus ②After suitable for timing, the tin is clicked and melted, take out the chip。 3、Weld the chip。 ①Clean the pad。 ②Coating help solder flux (should not thick too , can have first more thin ) and soldering tin ball。