Product Description

UL SAA CE IP*5 **0W LED High Bay Light- **0LM/W ( Copper Heat Pipe System Heat-sink),Meanwell driver design.


Specification:

Item Number: LY-HBL***0W-Z*5A / LY-HBL***0W-Z**0A

Power: **0W

Power Factor: more than0.*7

Input Voltage:  AC *****5V

Frequency Range:  *0Hz / *0Hz

Color Rendering Index: more than *5

Beam Angle:  *5 degree or **0 degree

Color Temperature:  ********0K  or ********0K

Luminous Efficiency :**0 lm/w

Lamp Lumen Output : ****6 lm

LED Brand: CREE XP-G: *5pcs

Power Supply Brand: MEAN-WELL HLG***0H**6A

IP Grade: IP*5

Warranty:  **5 years

Application:

1. Factory   2. warehouse  

3. workshop   4. storehouse  

5. hangar   6. gym, stadium, exhibition hall 

7. gas station, toll station 

8. Parking garage  9. mall   etc.

 

CE(EMC/LVD), RoHS, FCC, C-tick, SAA available.

Contact: sales (at) liangyangtech (dot) com

Attention:

1 It is forbidden to squeeze the top of the lamp, so as not to damage the  lamp shade.

2 Yellow green line to protect the earth, the rest two for ac power

cord.

3  When installation, hanging ring must be tight, in case lead to the lamp  body fall off

4 Because this product uses the heat pipe thermal conductivity, so it is strictly prohibited collision fall

5     When installing a lampshade, hang up the screws on the

composite  aluminum plate suspended within **3 mm

6     Install the lamp shade on the aluminum plate, screw

corresponding   with hole , then clockwise rotating lamp shade, Let

the nut into the  chimney hole and lock it

7 As LED high bay use heat pipe technology , lamp must be hang

perpendicular to the ground, deflection Angle is not greater than *5

degrees. the wire rope on heat sink is used to protect lamp body, to

prevent fall off. The rope must be connected to the fixed building can

bearing, to avoid lamp body  fall off lead to goods damaged or personnel  injury


UL SAA CE IP*5 **0W LED High Bay Light- **0LM/W ( Copper Heat Pipe System Heat-sink),Meanwell driver design.